How to Use Our Dr. NumbSkin 10.56 COMBO -

NumbSkin 10.56% is also called NumbSkin Blue. NumbSkin Cream is also known as NumbSkin 10.56% Numbing Anesthetic Cream. It is a set of pain relief products containing 10.56% lidocaine. It also includes Dr. Numb 4% Topical Foam Soap*.

NumbSkin 10.56% is a potent lidocaine 10 numbing cream that effectively alleviates discomfort during various aesthetic procedures. These include tattooing, microblading, microneedling, injections, electrolysis, laser treatments, plasma fibroblast tightening, permanent makeup, scalp micropigmentation (SMP), dermal pain, and other aesthetic procedures.

NumbSkin 10.56% is a pure lidocaine cream that does not interfere with tattoo ink. Lidocaine works by blocking nerve signals.

Dr. Numb 4% Topical Foam Soap

FDA-regulated numbing soap has a stronger formula than similar topical anesthetics. It offers the highest active ingredient level while staying within recommended safety limits.

DO NOT apply NumbSkin Cream over makeup.

Instead, use the Dr. Numb Foam Soap to remove makeup. Use it to cleanse and sanitize skin before applying NumbSkin cream.
However, use Dr. Numb Topical Anesthetic Foam Soap before, during, and after the procedure to soothe and numb the area. Shake thoroughly prior to every use.
Keep the cap tightly on when you don’t use the product; otherwise, your product may lose potency.
First, apply the Dr. Numb Foam Soap onto the treatment area and rub it in well.
Allow it to air dry, or gently blot dry using gauze or tissue.
Then, apply NumbSkin 10.56% Cream according to the instructions below.

Enhance Lidocaine Anesthetic Effect

If You Did Not Purchase Our COMBO or Do Not have Dr. Numb 4% Topical Foam Soap

Spread a generous layer of NumbSkin 10.56% Cream over the area and massage it in well; then add a second, thicker “icing” coat.
Apply Press n’ Seal in sections to cover the area.
Cut it to fit, and leave a small overlap.
This helps it stick to the surrounding skin.
The warmth of your skin will activate the cream, preventing it from drying out or gunking up.
Also, some practitioners recommend placing a warm towel over the Press n Seal. This can boost lidocaine’s numbing effect.
Leave it until the skin is completely numb, about 15-20 minutes.
Ask your practitioner to gently unwrap the covering as they work.
Have them do it section by section, since the anesthetic can weaken as it dries.
Reapply anesthetic if the sensation recurs.
Always close the tube tightly when not in use.